TIG Welding Certification Exams – Concepts For Passing the Weld Test
Spread the love

What do Boilermakers, Pipefitters, and Aerospace welders have in widespread?

Passing a TIG welding certification test is often required in order to be considered an expert welder or to even be employed for the job throughout the first place.

For boilermakers and pipefitters a pipe or tube welding test is often required and may very well be wherever from 3/8″ to 12 inches in diameter and counting on the job, the material welded is often carbon steel or stainless-steel, or carbon steel welded with ER309 filler metallic. (usually completely different alloys are welded nevertheless carbon and stainless make up the vast majority of welding exams given)

Aerospace welders, nevertheless, is prone to be required to weld nearly any metallic:

  • carbon steel / low alloy steel – 4130, 4140, 4340, 8630
  • stainless-steel – 321, 347, 13-8, 15-7, 17-7, a286
  • nickel alloys – Hastelloy x, Inconel 718
  • aluminum – A355,356,357 castings, 6061, 2219
  • magnesium – az31b,
  • titanium – 6AL4V, CP
  • cobalt – L605, Haynes 188
  • refractory alloys like columbium

Aerospace tig welding certifications exams are usually straightforward groove welds or fillet welds till the actual utility provision of the American Welding Society D17.1 is used. Usually, a straightforward groove or fillet weld test does not exactly symbolize the scope of welding carried out.

In that case, there is a provision for the welder to be licensed using a scrap half, dwell half, or mock-up test that represents the weld accomplished in manufacturing. It is an additional restricted certification nonetheless it helps to certify a welder on duties that adequately test the flexibility set required to do the job.

For Boilermakers and pipefitters, a tig welding certification test on tube or pipe nearly represents the similar joint accomplished throughout the topic.

Concepts for passing any tig welding test:

  • purge…give quite a few consideration to getting a great purge by guaranteeing ends are taped neatly and securely with a vent hole on the excessive for gasoline to flee.
  • Clear the metallic…Whether or not or not welding a pipe joint or sheet metallic butt weld, within the occasion you don’t clear the metallic correct, you will perhaps fail. Metals like aluminum and titanium are weak to porosity and submitting the sting removes crud that may set off porosity…Some test inspectors will fail you on the spot just for not cleaning the metallic.
  • For aerospace tig welding exams, make sure to file the sheared fringe of the metallic
  • Degrease with acetone or completely different permitted solvent…give the rod a wipe too.
  • Adjust to instructions…Whether or not or not written or out of your test supervisor, focus, study, and adjust to instructions.

Source by Jody Collier

Leave a Reply

Your email address will not be published. Required fields are marked *